How to Set Up Hornady Lock-N-Load AP Press
Setting up the Hornady Lock-N-Load AP Press is a crucial step in ensuring accurate reloading for your firearms. This press is renowned for its precision and durability, making it a favorite among reloaders. In this article, we will guide you through the process of setting up your Hornady Lock-N-Load AP Press, ensuring that you can start reloading with confidence.
Step 1: Unboxing and Inspection
First, carefully unbox your Hornady Lock-N-Load AP Press and inspect all the components. Make sure that all the parts are present and in good condition. Check for any damage or missing parts before proceeding.
Step 2: Assemble the Press Base
Start by assembling the press base. Place the base on a flat and sturdy surface. Attach the four base feet to the base using the provided screws. Ensure that the feet are securely fastened to provide stability during reloading.
Step 3: Install the Press Head
Next, install the press head. Place the press head on top of the base and align the holes in the head with the holes in the base. Secure the head to the base using the provided bolts and nuts. Tighten the bolts evenly to ensure a secure fit.
Step 4: Mount the Die Setter
The die setter is an essential component for achieving consistent reloading pressure. Mount the die setter to the press head using the provided mounting bracket. Ensure that the die setter is securely attached and aligned with the press head.
Step 5: Install the Priming Unit
Attach the priming unit to the press head. The priming unit is designed to hold and feed primers into the reloading die. Follow the manufacturer’s instructions to install the priming unit correctly.
Step 6: Attach the Case Feeder
The case feeder is responsible for feeding cases into the reloading process. Attach the case feeder to the press head using the provided mounting bracket. Make sure the feeder is aligned with the case opening in the press head.
Step 7: Install the Powder Measure
Attach the powder measure to the press head. The powder measure is used to dispense the correct amount of powder for each cartridge. Follow the manufacturer’s instructions to install the powder measure securely.
Step 8: Adjust the Press
Before starting the reloading process, adjust the press to ensure proper alignment and operation. Check the alignment of the press head, die setter, priming unit, and case feeder. Make any necessary adjustments to ensure smooth and accurate reloading.
Step 9: Test the Press
Once the press is fully assembled and adjusted, test it to ensure it operates correctly. Load a few cases using the press and inspect the results. If everything is functioning as expected, you are ready to start reloading with your Hornady Lock-N-Load AP Press.
Conclusion
Setting up the Hornady Lock-N-Load AP Press is a straightforward process that requires attention to detail. By following these steps, you can ensure that your press is properly assembled and ready for accurate reloading. Enjoy the precision and efficiency that the Hornady Lock-N-Load AP Press offers in your reloading endeavors.
