How to Do Outside Corner Crown Molding
Crown molding adds a touch of elegance and sophistication to any room, and installing it is a great way to enhance the overall look of your home. One of the most challenging aspects of crown molding installation is dealing with outside corners. In this article, we will guide you through the process of how to do outside corner crown molding, ensuring a seamless and professional finish.
Step 1: Measure and Cut the Molding
Before beginning the installation, it’s essential to measure the outside corner accurately. Use a tape measure to determine the length of the molding needed to fit the corner. Add a small allowance for any cuts or adjustments. Cut the molding to the desired length using a saw, ensuring the ends are square.
Step 2: Apply Adhesive
Once the molding is cut, apply a thin, even layer of adhesive to the back of the molding. Use a caulk gun to apply the adhesive, ensuring you cover the entire back surface. Avoid applying too much adhesive, as this can cause the molding to sag or bubble.
Step 3: Position the Molding
Start by placing the molding at the corner, aligning it with the ceiling and wall. Use a level to ensure the molding is perfectly vertical and horizontal. If the molding is too long, carefully trim it using a saw or a miter box.
Step 4: Secure the Molding
Once the molding is in place, secure it to the wall and ceiling using finishing nails. Drive the nails through the molding at approximately 6-inch intervals, being careful not to overdrive them. Use a nail set to countersink the nails, then fill the holes with wood filler.
Step 5: Trim the Molding
After the adhesive has dried and the nails are set, trim the excess molding from the corner using a utility knife. Be sure to hold the molding firmly in place to avoid damaging it. Clean up any remaining adhesive or wood filler with a damp cloth.
Step 6: Paint or Stain the Molding
Once the molding is installed and trimmed, it’s time to finish it. Paint or stain the molding to match the room’s decor. Use a brush or roller to apply the paint or stain, ensuring even coverage. Allow the finish to dry completely before adding any additional trim or decorations.
By following these steps, you can successfully install outside corner crown molding in your home. Not only will it enhance the aesthetic appeal of your space, but it will also provide a durable and long-lasting finish. Happy molding!
